Petrol Post Driver

From: £28.75

Hire PeriodRate
4 Hours£28.75
8 Hours£36.25
1 Day£50.00
2 Days£75.00
3 Days£87.50

All rates exclude VAT

  • *Hire Period

    Reset options

    *Post Adapters

    Select the adapters you require

    Driving posts which are significantly smaller than the adapter will result in instability while operating the Post Driver. It will also affect the efficiency of the Post Driver. This may result in injury to the operator and will result in damage to Post Driver.

    Ensure there is a maximum clearance of 10mm between POST and ADAPTER (5mm each side).

    The Pilot Core Tool is included with the Petrol Post Driver, click above to expand this section, and read about when it is required.

    The Pilot Core Tool is used with the Petrol Post Driver and enables you to remove a core of earth out of the ground prior to driving in your stakes. When the ground is hard, bone dry or rocky it enables the job to take place in any condition, and it speeds up the overall time of driving each post in.
    Also recommended when the ground is made up of heavy clay, or chalk.

    – Increase productivity driving 90mm-100mm diameter posts.
    – Cutting Head heat treated; extremely hard & durable.

    Instructions for Use
    – Fit the 107mm Adapter to the Petrol Post Driver.
    – Slide the Spacer Collar onto the Pilot Core Tool.
    – Drive the Pilot Core Tool in the required location.
    – Drive to a depth of 150mm (6”) less than the required post depth.
    – Insert the T-Bar horizontally into the Pilot Core Tool. Use a stake as a lever, then Twist & Pull to remove the Core of Earth.
    – The ground is now prepared to drive your stakes with the Easy Petrol Post Driver.

    If the ground is exceptionally dry, fill the hole with water & allow to soak for a few minutes. An increased moisture content in the soil will enable stakes to drive much faster.

    • £
  • *Hire From

SKU: N/A Category:


Engine HondaGX160
Max output800 l/min
Debris size capacity25mm
Inlet/outlet diameter50mm
Total head26m
Suction head8m
Pressure2.6 bars
Dry Weight33kg
Fuel tank capacity3.3L
Length x Width x Height570mm x 430mm x 400mm


There are no reviews yet.

Only logged in customers who have purchased this product may leave a review.

Product Enquiry

    Name (required)

    Email (required)